Yanmar BY series Specifikace Strana 85

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 127
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 84
PERIODIC MAINTENANCE
78 BY Series Operation Manual
Keep a Log of Engine Hours and
Daily Checks
Keep a log of the number of hours the
engine is run each day and a log of the
daily checks performed. Also note the
date, type of repair (e.g., replaced
alternator), and parts used for any service
needed between the periodic maintenance
intervals. Periodic maintenance intervals
are every 50, 250, and 500 engine hours.
Failure to perform periodic maintenance
will shorten the life of the engine.
Yanmar Replacement Parts
Yanmar recommends that you use genuine
Yanmar parts when replacement parts are
needed. Genuine replacement parts help
ensure long engine life.
Tools Required
Before you start any periodic maintenance
procedure make sure you have the tools
you need to perform all of the required
tasks.
Ask Your Authorized Yanmar
Marine Dealer or Distributor For
Help
Our professional service technicians have
the expertise and skills to help you with
any maintenance or service related
procedures.
Required EPA Maintenance
To maintain optimum engine performance
and compliance with the Environmental
Protection Agency (EPA) Regulations
Engines, it is essential that you follow the
Periodic Maintenance Schedule on
page 79 and Periodic Maintenance
Procedures which start on page 83.
EPA REQUIREMENTS
The EPA emission regulation is applicable
only in USA.
Conditions to Ensure
Compliance with EPA Emission
Standards
This product is an EPA-approved engine.
The following are the conditions that must
be met in order to ensure that the
emissions during operation meet the EPA
standards. Be sure to follow these:
The operating conditions should be as
follows:
Ambient temperature: -16° to +40°C
(-3° to 104°F)
Relative humidity: 80% or lower
4BY: Maximum exhaust backpressure:
18.0 kPa (1835 mmAq) or lower
6BY: Maximum exhaust back pressure:
20.0 kPa (2039 mmAq) or lower
Maximum air inlet restriction: 25 mbar
Be sure to perform inspections as outlined
in Periodic Maintenance Procedures on
page 83 and keep a record of the results.
Zobrazit stránku 84
1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 126 127

Komentáře k této Příručce

Žádné komentáře