Yanmar 6LPA-STZP2 Specifikace stáhnout pdf (Strana 46)

ENGINE OPERATION

40 6LPA Series Operation Manual

NOTICE

NEVER hold the key in the START

position for longer than 15 seconds or

the starter motor will overheat.

7. The alarm should stop and the

indicators should go out.

NOTICE

If any indicator fails to illuminate when

the key switch is in the ON position, see

your authorized Yanmar Marine dealer

or distributor for service before operating

the engine.

Note: When the engine has not been

used for a long period of time,

check that the key can move

from the START position to the

ON position smoothly.

If the Engine Fails to Start

Before turning the key switch again, be

sure to confirm that the engine has

stopped completely. If an attempt to restart

is made while the engine is running, the

pinion gear of the starter motor will be

damaged.

NOTICE

NEVER hold for longer than 15 seconds or

the starter motor will overheat.

NEVER attempt to restart the engine if the

engine has not stopped completely. Pinion

gear and starter motor damage will occur.

Note: Hold the key switch for a

maximum of 15 seconds. If the

engine does not start the first

time, wait for about 15 seconds

before trying again.

NOTICE

If the vessel is equipped with a water lift

(water lock) muffler, excessive cranking

could cause seawater to enter the

cylinders and damage the engine. If the

engine does not start after cranking for 15

seconds, close the thru-hull water intake

valve to avoid filling the muffler with water.

Crank for 10 seconds at a time until the

engine starts. When the engine does start,

stop the engine immediately and turn off

the power switch. Be sure to re-open the

seacock and restart the engine. Operate

the engine normally.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 105 106

Komentáře k této Příručce

Žádné komentáře