Yanmar 1GM10V Specifikace stáhnout pdf (Strana 37)

5. Trouble and Troubleshooting

5. TROUBLE AND TROUBLESHOOTING

*Note: Other warning lamps do not go on when the switch is turned on. They only go on when there is an abnormality.

Trouble Probable Cause Measure

Reference

Alarm Buzzer and Alarm

Lamps On During

Operation

Shift to low speed operation immediately, and check which lamp has come on. Stop

the engine for inspection. If no abnormality is identified and there is no problem with

operation, return to port at your lowest speed and request repairs.

Eng.Lube Oil Press.

Warning Lamp goes on

Engine Lube Oil insufficient;

Fuel filter clogged.

Check Lube Oil Level.

Replenish or replace.

3.2.2

4.3.1(1)

*Water proof warning lamp

goes on

Breakage of seal mount on the sail drive. Check and change the rubber

mount.

Faulty Warning Devices

Do not operate the engine if alarm devices are not repaired.

Serious accidents may result if difficulties are not spotted due to faulty alarm lamps.

When switch is turned ON:

Alarm buzzer does not sound. Circuit broken or buzzer defective. Ask for repairs.

Warning lamps do not go on Eng. Lube Oil Press.

Seawater.

No current available.

Circuit broken or lamp burnt out.

Ask for repairs.

One of the warning lamps

does not go out

Sensor switches faulty. Ask for repairs.

Charge lamp does not go out

during operation

V-belt is loose or broken.

Battery defective.

Alternator power generator failure.

Replace V-belt; adjust tension.

Check fluid level, specific gravity;

replace.

Ask for repairs.

4.3.4(3)

4.3.2(4)

002550-00E

GM OPERATION.book 37 ページ２００４年１０月４日　月曜日　午前１１時１１分

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Komentáře k této Příručce

Žádné komentáře

Yanmar 1GM10V Specifikace Strana 37

Komentáře k této Příručce

Související produkty a manuály pro Motor Yanmar 1GM10V