Yanmar 1GM10V Specifikace stáhnout pdf (Strana 26)

3. Operation

26

4. Continue to pull out the engine stop

knob (stop lever) until the engine is

completely stopped. If you release the

knob before the engine has completely

stopped, it may restart.

5. Close the fuel tank cock.

6. Close the sea cock.

Neglecting to close the Kingston cock

will allow water to leak into the boat

and may cause it to sink. Be sure to

close the cock.

Note: The engine may be stopped by

pulling out the decompression

lever, but avoid doing so except in

times of emergency.

In this case, the engine is stopped

by cutting off the air pressure.

However, fuel injection does not

stop, and fuel is leftover in the

combustion chamber.

This will lead to abnormal

combustion when the engine is

restarted and is not desirable.

002550-00E

3.4 Long Term Storage

In cold temperatures or before long term

storage, be sure to drain the water from

the seawater cooling system.

Drain water from the

cooling system after the engine has

cooled down. Be careful to avoid burns.

If water is left inside, it

may freeze and damage parts of the

cooling system cylinder block, seawater

pump, etc.)

1. Loosen the drain cock at the side of

the thermostat cover, and drain off the

water inside.

2. Loosen the 3 bolts fixing the side cover

of the seawater pump, remove the

cover and drain the water from inside.

Retighten the bolts when finished.

3. Close the drain cock.

002696-00E

002550-00E

002561-00E

Outlet

Seawater pump body

Impeller

Packing

Side cover

Cam

Inlet

GM OPERATION.book 26 ページ２００４年１０月４日　月曜日　午前１１時１１分

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Komentáře k této Příručce

Žádné komentáře