Yanmar 4JH3-TCE Specifikace stáhnout pdf (Strana 28)

28

6. Periodic Inspections and Maintenance

EN

6.2.2.7 By using Yanmar hand

pump

First follow steps (1), (2), (3), (4) on page

26.

(1) Connect the hose from the bottom

and a suction hose to Yanmar

pump with hose clip like shown

above.

(2) Take out the plug from the upper

case cover.

(3) Fill oil by pumping it into drive. Be

aware that oil has to flow up

through narrow parts. Therefore,

pumping will be hard. A few min-

utes waiting in between will help.

After pumping in about 1 liter of oil,

screw in the oil changing plug (do

not forget to insert the gasket).

Please be aware that the drain hose

can easily slip out of the bucket and

cause oil spilling. The hand pump

(p/#: 28210-000080) and rubber

hose (p/#:196440-92970) are avail-

able from Yanmar, and are optional

parts for SD50/-4T. Or any type of

hand pump or rubber hose (Inner

diameter ø14-16 mm) available

from the hardware shop, are us-

able.

(4) After filling, first screw in and tight-

en the plug at the top cover. Then

remove the pump, hose and adapt-

er joint and screw in the oil drain

plug (do not forget to insert the gas-

ket).

6.2.2.8 By not using pump

For the oil filling procedure by not using

pump, see the explanation on chapter 4.,

page 10.

APlug

A

003871-00E

003872-00E

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Komentáře k této Příručce

Žádné komentáře