Yanmar 3HM Uživatelský manuál stáhnout pdf (Strana 17)

IV. After launching

1) Check for water or air intake around the gland part of the stern tube and the kingston cock

fitting.

2) Make sure that the engine installation bolts and shaft joints are firmly secured.

3) Release compression with the decompression lever and slowly run the engine with the

engine starting handle. Relative compression can be determined by comparing the weight (re-

sistance when turning) of the clutch handle when placed in the neutral, ahead, and astern

positions. When there is little weight difference among the three positions, decompression is

complete. If the clutch is heavier when engaged than when disengaged, this indicates that the

shaft is not in the correct position. If the engine is operated under this condition, a broken

propeller shaft may result. Check the alignment of the propeller shaft and the engine.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Žádné komentáře

Yanmar 3HM Uživatelský manuál Strana 17