Yanmar 1GM10V Specifikace stáhnout pdf (Strana 32)

Adding Marine Gear Oil

1. Make sure the engine is as level as

possible.

2. Remove the filler cap / dipstick

(Figure 6, (1)) at the top of the housing.

3. Fill with oil to the upper limit on the

dipstick (Figure 6, (2)). NOTICE:

NEVER overfill the marine gear with

oil.

4. Fully reinsert the dipstick.

5. Hand-tighten the filler port cap.

Checking and Adding Sail-Drive

Oil

Refer to the Sail-Drive Operation Manual for

the procedure for checking and filling the

sail-drive oil.

CRANKING THE ENGINE

MANUALLY

NOTICE: When performing engine

break-in or if the engine has not been

used for a long period of time, engine oil

will not be distributed to all the

operating parts. Using the engine in this

condition will lead to seizure.

After a long period of non-use, distribute

engine oil to each part by cranking the

engine. Perform the following procedure

before beginning operation:

1. Open the seacock.

2. Open the fuel cock.

3. Put the remote control shift lever in the

NEUTRAL position.

4. Raise the decompression lever

(Figure 7, (3)) up.

(3)

(2)

(1)

0005838

Figure 7

1 – RUN Position

2 – Decompression Position

3 – Decompression Lever

BEFORE YOU OPERATE

26 GM Series Operation Manual

© 2007 Yanmar Marine International

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 91 92

Komentáře k této Příručce

Žádné komentáře