Yanmar ZT370 Specifikace stáhnout pdf (Strana 45)

MAINTENANCE

12/05

ZT370 Operation Manual 41

Perform the following maintenance every

250 hours of operation.

• Touching-up the stern-drive paint and

spray with corrosion guard

• Retorqueing the rear engine mounts

• Changing the stern-drive oil

• Lubricating the drive unit and

universal-joint shaft splines and

O-rings

• Torqueing the rear engine mount

bolts

■ Touching-up the stern-drive paint

and spray with corrosion guard

Corrosion damage that results from

improper application of anti-fouling paint

will not be covered by the warranty.

Painting vessel hull or vessel transom:

Anti-fouling paint may be applied to the

vessel hull and the vessel transom.

NOTICE

Never paint the anodes or Y-CaPS

electrode. Painting these components will

render them ineffective as galvanic

corrosion inhibitors.

NOTICE

Use copper-based paint as anti-fouling

protection for the vessel hull or vessel

transom, as long as it is not prohibited by law

in the area where the vessel will be

operated. If using copper- or tin-based

anti-fouling paint, avoid an electrical

interconnection between the Yanmar

Product, anodic blocks, or Y-CaPS and the

paint by allowing a minimum of 40 mm (1 -

1/2 in.) of UNPAINTED area on the transom

of the vessel and around these items.

Figure 9

NOTICE

The drive unit and transom assembly can

be painted with a good quality marine paint

or an anti-fouling paint that does not

contain copper or any other material that

could conduct electrical current. Never

paint drain holes, anodes, Y-CaPS or

items specified by the vessel

manufacturer.

NOTICE

Never wash the stern-drive with a power

washer because it can damage the coating

on the reference wire and increase

corrosion.

■ Retorqueing the rear engine

mounts

See Torqueing the rear engine mount bolts

on page 46.

■ Changing the stern-drive oil

Note: The stern-drive oil must be changed

every 250 hours or every year,

whichever comes first.

Every 250 Hours of Operation

039084-00E00

Minimum 40 mm

(1-1/2 in.) of

unpainted area

around transom

assembly

Painted

vessel

transom

Maintenance.fm 41 ページ２０１３年９月２７日　金曜日　午後１時１６分

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

Komentáře k této Příručce

Aurelio 29 Oct 2024 | 18:29:11

Necesito manual de reparación completo por favor.