Yanmar 6LYA-STP Specifikace stáhnout pdf (Strana 38)

4.3.1 Inspection after Initial 50 Hrs. Operation

（1）Replacing the Engine Lube Oil and Lube Oil Filter (1st time)

During initial operation of the engine, the oil is

quickly contaminated due to the initial wear of

internal parts. The lube oil must therefore be

replaced early.

Replace the Iube oil filter, too, at this time.

Engine lube oil is convenient to drain before the

engine has cooled down.

①Remove the lube oil dipstick and connect

the hose of the drain oil pump (optional part)

to the guide of the oil dipstick.

②Prepare a container to receive drain oil and

pump out oil using the drain oil pump.

③Remove the lube oil filter with the filter

wrench.

(Turn counterclockwise. )

④Clean the filter installation face.

⑤Screw the lube oil filter fully into the installa-

tion face by hand and further fasten the filter

by about 3/4 turns with the filter wrench.

(Turn clockwise.)

⑥Supply new lube oil to the specified level.

(See 3. 2. 2.)

Test operation the engine for 5 minutes.

Check that no oil leaks out during operation.

⑦Wait about 10 minutes after stopping the

engine. Check the oil level with the oil

dipstick and refill to the specified level.

Beware of oil splashes if

extracting the lube oil

while it is hot.

4.3 Periodic Inspection Items

CAUTION

Fresh water tank

Fresh water

cooler

Starter motor

Drain oil pump

Lube oil filter

(Full flow)

Inter cooler

(By-pass)

Lube oil filter Yanmar P/N

Full flow 119593-35100

By-pass 119593-35400

[Fig.19]

[Fig.18]

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 54 55

Komentáře k této Příručce

Žádné komentáře

Yanmar 6LYA-STP Specifikace Strana 38

Komentáře k této Příručce

Související produkty a manuály pro Motor Yanmar 6LYA-STP