Yanmar 1GM10 Specifikace stáhnout pdf (Strana 37)

BEFORE YOU OPERATE

GM Series Operation Manual 31

12/05

3 – Upper Limit

4 – Lower Limit

3. Fully reinsert the dipstick.

4. Remove the dipstick. The oil level

should be between the upper

(Figure 5, (3)) and lower

(Figure 5, (4)) lines on the dipstick.

5. Add oil if necessary. See Adding

Engine Oil on page 31.

6. Fully reinsert the dipstick.

Adding Engine Oil

NOTICE

Prevent dirt and debris from contaminating

the engine oil. Carefully clean the dipstick

and the surrounding area before you

remove the cap.

1. Remove the yellow oil filler port cap

from filler port (Figure 5, (1)) on the

rocker arm cover and fill with engine oil.

2. Fill with engine oil to the upper limit

(Figure 5, (3)) on the dipstick

(Figure 5, (2)).

NOTICE

Never overfill the engine with engine oil.

3. Insert the dipstick fully to check the level.

NOTICE

Always keep the oil level between upper

and lower lines on the oil cap / dipstick.

4. Hand-tighten the filler port cap securely.

MARINE GEAR OR

SAIL-DRIVE OIL

Marine Gear Oil Specifications

Use marine gear oil that meets or exceeds

the following guidelines and classifications:

KM2P-1 (S), (G) or (GG):

• API Service Categories: CD or higher

• SAE Viscosity: #20 or #30

Sail-Drive Oil Specifications -

SD20

Refer to the Sail-Drive Operation Manual

for the procedure to fill or replace the drive

oil.

SD20:

• API Service Category: CC or higher

• SAE Viscosity: 10W-30

Engine Oil Capacity

1GM10 (V) (C) Full: 1.5 L (1.6 qt)

GM_OM.book 31 ページ２０１３年６月１０日　月曜日　午後２時２６分

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 93 94

Komentáře k této Příručce

Žádné komentáře